# UGREEN Nexode PD Charger Under-Desk Mount
## Overview
This is a 3D printable mount designed to attach your UGREEN Nexode PD Charger under a desk or table. The mount helps keep your workspace clean and organized by moving the charger off your desk surface while keeping it easily accessible.
## Features
- Custom-designed to fit UGREEN Nexode PD Charger models
- Under-desk mounting solution
- Easy access to charging ports
- Clean cable management
- Space-saving design
## Technical Details
- File format: STL (3D printable)
- Recommended print settings:
- Layer height: 0.2mm
- Infill: 20-30%
- Support: Yes (for mounting brackets)
- Material: PLA or PETG
- Orientation: Print with the largest flat surface on the build plate
## Installation
1. Print all parts using the recommended settings
2. Clean up any support material
3. Attach the mount to the underside of your desk using screws (not included)
4. Insert the UGREEN Nexode charger into the mount
5. Organize your cables through the designated paths
## Compatibility
- Designed specifically for UGREEN Nexode PD Charger
- Works with most desk surfaces
- Minimum desk thickness required: 15mm
## Safety Notes
- Ensure proper ventilation around the charger
- Check that all mounting screws are securely fastened
- Make sure the charger is firmly seated in the mount before use
## Additional Information
- Print time: Approximately 3-4 hours
- Material usage: ~50-70g depending on settings
- Designed for easy removal and installation of the charger when needed
The author marked this model as their own original creation.