Remixed 3D-Touch BL-Touch mount for ELEGOO Neptune 2

Print Files

• ElegooNeptune2BLTouchMount-v3-remix
  Same as the upstream part, but moves the touch probe mount 2.5mm to the right
  
  Tested working with the mS_Neptune_Dual_4010_1.0.stl from the mini satsana model
  
  Updates to the original part's docs:
  This mount has offset of X is 48.75 and offset of Y is 0.
  You can setting up your printer by using elegoo.txt lines below and ELEGOO's standard procedure.

>Z_PROBE_OFFSET_FROM_EXTRUDER 0     # Z offset: -below +above  [the nozzle]  
>X_PROBE_OFFSET_FROM_EXTRUDER 48.75 # X offset: -left  +right  [the nozzle]
>Y_PROBE_OFFSET_FROM_EXTRUDER 0     # Y offset: -front +behind [the nozzle]

• ElegooNeptune2BLTouch_shim
  
  When using this part as a mount, my touch probe would extend quite a bit past the nozzle, but wouldn't trigger until after the nozzle crashed into the build platform.
  
  I tested with a stack of post-it notes what additional Z-offset the probe would need to trigger properly and it seemed that between 1-2mm would be sufficient.
  
  I've had similar problems with other touch probe mounts, It's probably that my probe works slightly differently than others.
  
  I used meshmixer to cut up the upstream model into a 1mm slice.
  
  You can use a similar process, then scale this part (it's 1mm thich) in the Z axis to produce a shim that's ideal for your use.

Print settings:

• material: PLA
• layer height: 0.2mm
• wall thickness: 1.2mm
• top/bottom thickness: 1mm
• infill density: 25%
• infill pattern: cubic

• Moves touch probe 2.5mm to the right to avoid reports of it hitting the fan
• Add z shim file to allow fine tuning the z position