Wood load in 1:87 H0 scale for open goods wagons UIC type E.

Description

I have created these wood loads for my Piko 95432 open goods wagons UIC type E (not included in the models). This Piko wagon has inside measurements length 87 mm, width 29 mm and height 15 mm. 
You can rescale the models to adjust the measurements for your own open goods wagons.

I have printed using a 0.30 and 0.40 mm nozzle with layers set to 0.20 mm speed, intentionally ignoring the warnings of the Prusaslicer to get the rough 'woody' look.
This takes some experimenting to get the look 'just right', and in some occasions I had to glue together the parts that were a bit too loose. But I like the end result. 
I have created a few more variations than I needed myself so you can choose which variation you like the most.

The variations:
- Wood mixed placed 1-4. These need the 'Support 11mm' with a 15 mm inner height of the wagon.
- Wood lengthwise placed 1 and 2. These need the 'Support 11mm' with a 15 mm inner height of the wagon.
- Wood lengthwise placed 3 (wagon is not full). This needs 'Support 7mm' with a 15 mm inner height of the wagon.
- Wood traversely placed 1-3. These need the 'Support 11mm' with a 15 mm inner height of the wagon.
- Wood short 1-3. These need the 'Support 14mm' with a 15 mm inner height of the wagon.
- Wood short 4 and 5 (wagon is not full). These need the 'Support 11mm' with a 15 mm inner height of the wagon.
You can rescale the supports to adjust the measurements for your own open goods wagons.

Happy printing.