Hi Viz Socket Holder - Metric

This socket holder was created because I wasn't happy about the cost of US General socket holders and none of the other models seemed to work with Milwaukee sockets. 
This model was designed using Milwaukee 3/8 drive sockets as the base material but I have tested it with Craftsman as well and it works perfectly. I would assume it works with most other 3/8 drive sockets.

Features:

• Uses less than 76g of filament
• Number/socket size is well pronounced which means faster acquisition of desired socket!
• No multicolor system is needed! (Switch colors at 4.00 layer height and when the numbers are filled, switch it back!)
• Magnets are optional, but it does allow for 6mm x 2mm magnets to be inserted so it will stay in place in drawers.
• Holds both deep and shallow sockets and goes all the way up to 19mm
• Item is slotted so any left over grease does not stay sitting on printed item or your sockets (this also helps reduce filament cost)