This is a remix of the model I made for Raspberry Pi 5, but I modified it to fit Raspberry Pi 3.
0
12
0
66
updated January 8, 2025

Summary

PDF
This is a remix of the model I made for Raspberry Pi 5, but I modified it to fit Raspberry Pi 3.

Tags



Model origin

The author remixed this model.

Differences of the remix compared to the original

This is a modification of my model for Raspberry Pi 5, but it was modified to fit Raspberry Pi 3. Key changes except different board:

  1. Heat-inserts instead of screwing into plastic.
  2. Extra slots were added in the lower part for cooling.
  3. Extra slots were added on the side wall.

Print Settings

The table below shows the print settings used to print the model.

PropertyValue
FilamentPETG, ABS
Infill20%
Walls3-4
Top/bottom layers4
Layer0.2

Extra BOM

  1. Screw M3x20 SHCS - 2
  2. Screw M3x8 SHCS - 2
  3. Screw M2.5x10 BHCS - 4
  4. Nuts M2.5 - 4

 

License