Sortimo 3x3 Grid

Prusament PETG Prusa Orange
250°C Extruder, 85°C Bed
Nozzle 0,4mm, but I set it to 0,38mm in S3D.

There are two versions. (Check the comments to understand the problem)
In short.
If you put several grids next to each other, then there can be a gap between them. (Tolerances, shrinkage of the material).

SortimoGrid3x3.stl
This variant has a 8mm hole for the feet of the boxes.

SortimoGrid3x3_V2.stl
This variant has a 8.3mm hole for the feet of the boxes.

Give me some feedback if you try it out.
Thanks
Marco