OddityRC Toothpick canopy

Compatability: It has only been tested on the 5-inch version; however, it should fit the 4-inch version as well. Check dimensions for compatability with other frames. 

Dimensions: 

• Canopy outer dimenstions 51x51x19mm
• Hole spacing 32,5x32,5mm 
• (Small version: 25x25mm spacing)

Hardware: 

• Insert dia: 2mm
• Screws M2x10mm
• (Small version: M2 Stack screws)

Support my work: All of my models are available for free. If you'd like to show your appreciation, consider Buying Me A Coffee.

Design Features: The top of the canopy is thinner in the middle for better GPS satellite reception. I plan to use a GPS on the LOS drone for rescue in case I lose the orientation of the quad. 

3 different looks: 

• Shown in pictures

• For sligtly more prop clearance

• Smaller and mounts on top of the FC.

Filament: PLA

Change Log: 

Rev.1 : Cutouts for mounting inserts - When installing the inserts in the original design, the PLA melted around the attachment holes, as seen in the pictures.