I needed a filament guide that works from the Sunlu Dryer and normal Spoolholder through PTFE Tube. I found the Filament guide in a balanced way and liked the idea very much.
I redesigned the holder to be taller and works when the extruder gets to it's maximum hight. And a PTFE guide was also needed.
You can choose between the design with hole for Ptfe Guide or without.
For a nice honeycomb side you have to set in the print settings, no bottom and no top layers and about 4-5 perimeters. 15% Infill. You cand print it in PETG or PLA
For assembly you need
1 bearing 5mm x 16mm x 5mm
1 M5x15 screw
At first you will need a little presure to lock it into the Prusa frame, but believe me, it fits.
The spining head with bearing is the same as from the original model from @pear3d.ch ( Filament guide in a balanced way) but i will also leave here all models.
The author remixed this model.