BOM
- adhesive (rubber, double-sided tape, fixed paste, etc.) to the parts in contact with the table, such as the top of the screw (diameter 35) and the bottom side of the top clamp (50x65).
- M6 screws for attaching the joystick
- 2x M3x25 screws
Printed parts
- Desk clamp
- Desk_clamp_screw
- Desk_clamp_screw_top
- Height adjustment screw
- holder_screw_1
- holder_screw_2
- holder_joystick
- Foam rubber_screw (To cut the foam rubber to size)
- Foam rubber_clamp (To cut the foam rubber to size)
Recommended parameters
- Nozzle size: 0.4 mm
- Layer height: 0.2 mm (Structural)
- 6 first and last layers
- min. 4 perimeters
- Infill : 40%
- Materials recommended: min. PETG
- No support on the thread of the screw
- 100% Infill for the screws, the head of the screw and the cylinder pin
Notes
- All printers have different tolerances, so it could be that the parts are either too loose or too tight for you
- Only intended for holding the joystick and not for leaning on it. You also don't lean on the gear stick of the car ;)
Tags
The author remixed this model.
Differences of the remix compared to the original
Höhenverstellbare Joystickhalterung, die Bohrungen an der Position angepasst, das Design und die Schrauben.