Sweep Bling MX Enclosed Case

Description

This case is for Sweep Bling MX keyboard. Tested working for DSA and XDA keycap profile.

BOM

For the full build you'll need 8x M2: 6mm screws

Building Instructions

1. For the bottom part, you will need to print it bottom side facing the build plate.
2. For the top part, you will need to print it with top side facing the build plate, with organic supports. When removing the support, you don't have to fully clean the remaining support material as the thickness of the excess support material is taken into account concerning the contact distance with the bottom of the switch. 

Print Settings

• Infill: 15-20% Cubic
• Layer height: 0.16mm
• Elephant foot Compensation: 0.2mm
• Ironing: No