RoeTest Case Mounts

General information

At the end of 2024, I set up version 11 of Helmut Weigl's RoeTest. In the process, I created some 3D designs that I am making available to the community in this collection. You can read more information about my build of the RoeTest and the use of the designs published here in my build report at Radio-Bastler.de (German) or on the RoeTest website (German).

About this Design

These blocks add mount points to the main assembly of the RoeTest. Most of the blocks are mounted to the spacers between the main board and the front panel. Two of the spacers can be mounted to the heat sink. I recommend to print the design in tough material like PCCF in 0.2mm layer height. You need to add self tapping inserts M3xM5x6mm.

Happy printing!

If you like this design, then please leave a like and also post a make in the comments.

You might also want to check out my other designs