Wireless Charger Case for USB C Unit

I went ahead and modified the original design to now fit the USB C variant of the wireless charger found here on AliExpress

When testing the 15W coils with an inline meter to the charger's input I found that the device drew ~12W max with a Samsung Note 20 Ultra.  I mostly went with this charger size for my earbuds though and they only drew about ~2W from the wall.

I used some 30-minute epoxy to glue down the wireless logo, it's a little time-consuming not to get the glue on the rest of the surface but using a toothpick helps with this process.

For the heat set inserts, I used some extras I had from my Voron builds but you can get them from most places. Here's a vendor I would recommend for within the US - Fabreeko

Also, a regular soldering iron set just above the printing temperature for the material used for installing the inserts should work fine.

Parts modified include,

• Changed from a magnet enclosure to a screw on top.  The parts used are listed below.

           - 2x M3 heat set inserts

           - 2x M3x10mm Flat Head Screws

• Increased the overall size of the device by 2mm to better accommodate the heat set inserts
• Opened up the hole in the side for the USB cord to be centered and fit most sizes of   USB C cords
• Added a spacer that when glued to the PCB gives the coil something flat to adhere to
• Added a wireless charging logo to the top cover just for looks mostly