This is a 2-Piece Design, Intended to be Wall Mounted and Hold the Vtech VM901HD Baby Monitor (Camera). This Cup Style Design Allows for Easy Access to the “On/Off” Switch and Also Plenty of Room for the Power Cable.
I Designed This with Intention of Wall-Mounting.
HARDWARE REQUIRED:
(1) 10-32 x 3/8" Panhead Screw (~$0.45 at Local Hardware Store)
(1) 10-32 Hex Nut (~$0.45 at Local Hardware Store)
(2) Drywall Screws w/ Optional Drywall Anchors.
NOTE: The Wall Mount Screw Holes are 3.5mm Diameter for the Screw, and 8.25mm Diameter for the Screwhead, with a Recess Depth of 4mm. I Based These Measurements Off of a Drywall Screw & Anchor Kit I Own.
-
I Printed This on my Bambu X1C with Polymaker PolyTerra PLA (Shown) with the 0.12mm Standard Profile. This Resulted in a 2hr 57min Print and a Material Cost of $1.29 (Plus Purchased Hardware)
The author marked this model as their own original creation.