Olight Diffusers Ultimate Bundle

Olight Diffusers Ultimate Bundle Growing list of diffusers for all recent Olight flashlights. Fast prints!
7
23
0
104
updated February 1, 2025

Description

PDF

Olight Diffusers Ultimate Bundle

If you are searching for a diffuser for your favorite Olight flashlight, you've come to the right place. I am creating a library of simple diffusers for every current Olight model and they are fast prints with minimal filament use. I have already finished the following:

Baton 4 / Baton 3 (S1R Baton II) 
Baton 3 Pro (S2R Baton II)
Baton Turbo
i1R2 Pro
i3E EOS
i3T 2 / i3T / i3T Plus
i5T / i5R / i5T Plus
Javelot
Javelot Mini
Javelot Pro 2 (probably also Javelot Pro)
Javelot Turbo
Marauder 2
Marauder Mini
Prowess
Seeker 4 Mini
Seeker 4 Pro / Seeker 4
Warrior Mini 3
Warrior Nano
Warrior 3S / Warrior 3 (M2R Pro Warrior)
Warrior X 4 / Warrior X 3
Warrior X Turbo
X9R Marauder

Up next:
Arkfeld (UV)
Arkfeld Pro
Arfeld Ultra
Arkflex
Perun 2
Perun 3
Perun Mini
Perun 2 Mini

Each diffuser has been carefully measured and the print profile has been made with dry, well-calibrated filament. There are several ready-made sizes for each model so that you can use the one you prefer. Of course, you can also modify the z measurement to your liking. Just make sure to deactivate uniform scale. The smallest size is intended to protect the flashlight lens from scratches while also serving as a mini diffuser.

Requests:
I only create diffusers for Olight flashlights since that is what I use. I will gradually release print profiles for all models except weapon and bike lights. The ones with (not final) are the ones I am currently working on. I can prioritize certain models if you ask for it. If you create your own print profile, please make sure to enable detect thin walls and there is no need for brims because PETG adheres well to the build plate.

Please use PETG for printing. I have tested the medium-sized diffuser with the Seeker 4 Pro's 4600 lumen turbo mode and it didn't get too hot, but modern flashlights with high output also create a lot of heat, so I advise against using PLA that already deforms at 55°C. The diffusers are as thin as possible to let the maximum possible amount of light through, so they not very sturdy, but you can always print a new one if one breaks. Please be careful when removing them from the build plate so that they don't break.

0.2mm layer height, 15% infill, no brims necessary. Use detect thin layers or a similar feature for the smallest models like the i3E.

Please note: If your print doesn't quite fit the model, it's probably because your filament is not calibrated correctly. You can experiment with making the X and Y measurements smaller/bigger in 0.05mm steps until you find the right size with uniform scale deactivated. Or better yet: Dry and calibrate your filament.

PS. Timelapse has been created on the A1 with this project: https://makerworld.com/en/models/859709

Tags



Model origin

The author marked this model as their own original creation.

License