Kallax splitter shelf

Ever wondered about splitting Kallax shelf in half? This print is right for you! Buy a simple 3mm board cut to 300x300mm squares, print all parts (4x edge A, 4x edge B and 4x leg), glue the frame while the square is inserted into the edges and you're good to go.

Print the edges on “front” face with the slot facing UP.

Print the legs on one of the flat sides, just keep in mind of how you would like to the part be looking (layers/bed surface)

To reinforce the edges, put a piece of filament to the holes and glue it in.

No supports needed if oriented right.

Photo is of my friend's console collection 😉

If printed in PLA, to glue the parts, Revell Contacta works great! (A plastic model kits glue that “welds” parts together)