Please read this information carefully before printing!
There are different clock movements and each one is designed a little differently. Therefore, the attachment methods may be different. Also, each printer is tuned a little differently. There may also be differences between different filaments.
Therefore, before you decide to use my clock hand models, take a good look at your clock movement, measure it, and make test prints.
If the hands don't fit properly (they need to be really tight so they don't slip), it may be enough to enlarge or reduce the model in the slicer by one or two percent.
The differences I am referring to are often in the order of tenths of a millimeter!
My models are precisely tuned to my printer and the filaments I use. Therefore, I would like to point out that accuracy is needed and that you should pay a little more attention to the dimensions. Fortunately, test prints only last a few minutes.
The author remixed this model.
I made some clock hands for my clock.