Octopi Adapter Plate MK2S and MK3

While looking for an Octopi case for my raspberry pi 2 on my new Prusa i3 MK2S printer, I quickly realized there were lots of great choices but all were created before MK2S was released.

I was already set on hofftari's excellent case https://www.thingiverse.com/thing:1325370 and had printed it before I realized MK2S changed the cable setup!

So searching around I found jackrenter's adapter plate https://www.thingiverse.com/thing:2265551, however I wanted to flip the Pi to the outside edge of the Prusa to give a more natural path for the raspi's camera cable and more properly orient the USB cables.

Thus this adapter plate was born to flip over the case and align with the right side of the Prusa frame. This works on MK2, MK2S and MK3 so long as you aren't using these holes for the MMU.

Print Settings

Printer Brand:

Prusa

Printer:

Prusa Mk2

**Rafts:** No

Supports:

No

**Resolution:** .15-.20

Infill:

20%

Post-Printing =============

Adapter Plate mounted on MK2S frame

hofftari's Octopi case mounted to adapter and flush with right side.

This is a much more natural position for the Pi case. The ribbon cable for the pi camera nicely routes out the right side and down below the chassis without interfering with the print area or prusa cables. The USB cable also routes nicely and leave the micros SD card up at the top for easy access.

Case is nicely flush on top and right side of frame.

How I Designed This ===================

Fusion 360

Category: 3D Printer Accessories