Streamlight 4AA Skadis Mount

A quick printing holder for the Streamlight 4AA models to attach your light to the Ikea Skadis boards.

I recommend 5 outer walls so the Skadis clips prints at its maximum strength. Some supports will be required.

The flashlight fit is a little loose to accommodate the variations between different flashlights. During my testing I found some lights to be up to 1.3 mm wider that others.

*Please note: that due to the variations of some factory Skadis walls you may be required to cut off the bottom tab as shown in the last picture. This will not effect the performance of the holder.

As always if you like my design please like and post a make.