Wetsuit Boot Dryer Insert Windsurfing Water

I have found that the inside of my wetsuit boots struggle to dry without being propped open, which is difficult to do, especially when away. So, I quickly designed this! 

These are designed to go inside your wetsuit boots to keep them open, allowing the wet air to escape. 

I have found they can also be used to do a similar thing with sailing gloves.

If you have smaller boots (I am a size 12), then I would suggest scaling the model down slightly.

I printed with PETG for the flexibility over PLA so it can be tossed in my bag afterwards. If needed, you can up the wall loop count.

I was able to print on my MK3.5S without support. I would advise a raft if you can.