Drain stand for IKEA SMÅÄTA cutting board

I'm using the IKEA SMÅÄTA cutting board and after the cleaning I had the problem, that the underside of the board was still wet, because the board stand in the dripping water.

After cleaning, you can place your cutting board on the stand and let it dry. 

Parameters for printing

• Material: PETG
• Layer heigth: 0.2 mm
• Infill: grid
• Infill density: 15 %

The time for printing was 55 min on the Bambu Lab P1S.

Other cutting boards
The stand should also work for other cutting boards.
The SMÅÄTA cutting board has a thickness of 15 mm, if your cutting board doesn't fit, write a comment so I can upload a fitting stand.