Wool Winder
Description
PDFBill of Materials:
4x M8x80mm Hex Head Bolts
2x M8 Washers
2x M8 Hex Nuts
5x 608 Skateboard bearings
Assembly Notes:
Use a washer between the stationary gear on the top and the carrier, as well as between the bolt and the large drive gear on the front.
Girlfriend Approved
Tags
Model origin
The author remixed this model.
Differences of the remix compared to the original
Made some structural changes as well as optimized for 3D printing.
Threader: Now one piece instead of two and can be printed on its side. Also adjusted its fitment as there was no allowance for the nut beside it.
Big Gear Handle Thing: Also one piece now, previously it has to be glued from two pieces which didn't make much sense to me.
Carrier & Bobbin: The joint would occasionally spin while winding as there was no mechanical connection, now there is a mechanical connection and it is not relying on the strength of my glue to turn the bobbin.