Nespresso Sleeve w/ label holder

A remix of the original which worked great, but I wanted a way to identify the pods since they are often impossible to ID if they aren't in their original box.  You can cut out a piece of the box, for example, and slide it in.

Recommend using the same settings as the original.  I printed these in PLA.  2 wall loops, 15% infill, use a brim but ensure you set it for “Outer Brim Only", and enable supports for the top piece, recommend tree supports.

The original lid is compatible, I made no changes that should interfere with that.  I added another version of the lid that extends forward to cover the label slot, if you want that.

Two versions here - with rail and without.  

With rail - I find that the pods twist a bit in the tube sometimes, the rail helps them stay aligned better.  Works pretty well, but I might keep messing with it.  If you want this version, print both bottom and top from this page.

Without rail - this just adds the label holder.  Print top from this page, and bottom from original page.

Two variations of top, one variation of bottom.  Added a rail inside to help guide the pods down for one version of the top.  For both versions of the top, added a slot to hold a label to identify the pods.