Upgrade new Belt X: ( It was tested on Artilleri X4 plus )
Models were printed from ASA (PETG)
Precision 0.12 mm
Speed 150mm/s
Material used for X4-Belt tensioner:
https://www.printables.com/model/1124661-1-artilleri-x4-pro-plus-upgrade-new-belt-y
New: Models Belt Holders + Washer
Material for X4-Base-microprobe-N:
For speed and acceleration I designed a new belt with a width of 7.7mm. Since the belt holder was not in the axis of the motor pulley, the positions (+1mm) of the holes for mounting on the linear guide were adjusted. Furthermore, the whole belt, if the head was stuck on both sides, was switched, so I added a washer for the linear guide.
With the author's consent, I corrected the model : https://www.printables.com/model/930869-mount-microprobe-v2-for-the-artillery-x4-pro-plus/comments
This sensor is incredibly accurate which is why I used it in my upgrade.
I want to point out that the length of the cable up to the motherboard is 1.5m. So you have to make it yourself. I inserted it into the main supply to the head of the cable extruder. You have to solder the JST 3pin 2.54mm connector into the board. The connection is in the link or in the attached photos.
In the next chapter I will describe how I fixed the cable so that it was not loose at the back. So if you remove the bottom plate, pull the cable outwards as much as possible (4-6cm) - picture.
There I also connected the ext USB for the camera - motherboard port. You need a USB 2.0 extension cable 70cm..unclip one end and insert a JST 2.0mm 4pin connector - see picture
Since you are changing belts, you must purchase a Resonance Compensation module. X4 plus S1 is included. I don't know how S1 will improve me - belt width?https://vi.aliexpress.com/item/1005007636216840.html?spm=a2g0o.order_list.order_list_main.40.12831802zt5Dab&gatewayAdapt=glo2vnm
I replaced the eMMC with a 32GB card + whith adapter USB 3.0
https://vi.aliexpress.com/item/1005007552996080.html?spm=a2g0o.order_list.order_list_main.45.454e1802vfEYkc&gatewayAdapt=glo2vnm
The instructions are on the artillery website and after flashing, don't forget to update the firmware to 1.5 (21Mb) because the image is from a year ago.
Artilleri X4 plus: In the config I have to override the nozzle cleaning positions back by 10mm
[gcode_macro nozzle_wipe]
gcode:
G1 X260 Y296 Z10 F3000
SET_KINEMATIC_POSITION Y=0
G1 Y35 F3000
The author marked this model as their own original creation.