Leatherman Skeletool Hammerbits Mod

Remixed the Skeletool hammer to hold 2 extra bits in the carabiner/bottle opener.
The bottom part snaps in place.  

v2 already available
extra plastic around the pin-hole & less… uhhh “glitches”?  The model is smoother, fits better & more clicky, also the installed bit acts to lock the top from opening when the skeletool is closed - print standing up on the flat end, not the hammer end, pin hole at the bottom.  It's stronger that way.  Bottom part is unchanged, absolutely perfect in every way.

Use a li'l superglue when putting the pin in & make sure the groove on the pin is rotated to allow the bit that's installed on the Skeletool to slot in place - give it a good squeeze before the glue sets.

If the bits are getting stuck when opening, you may need to pinch the bits with your fingers thru the carabiner opening to hold them in place while you open it. I figure it'll loosen up with use so I didn't make it more roomy inside

Hollowed out, added a pin