LifeVac Station (Remix)

Holder/Station for the LifeVac and Masks
This is a remix of LifeVac Station.

Features:

• Smaller and slimmer design.
• Slightly larger screw holes.
• Store up to four(4) masks.
• No need for zip bags—simply tie a knot or use a bag clamp.
• Compatible with the original bag or any other alternative. I personally prefer a regular open bag with a bag clamp, as it requires less strength compared to ripping a bag open. The bag clamp prevents the bags from sliding down through the slot while still allowing them to be easily removed and opened when needed.
• Recommended bag clamp: Bag Clamp - Fast Print.

Suggested Print Settings:

• Material: PETG (PLA likely works as well).
• Infill: 15% (Gyroid infill preferred).
• Printing Orientation: Print in the same orientation as when mounted. Note that the arms have a chamfered side, which should face up during printing.
• Supports: Not required.

Assembly Instructions:

1. Install the arms (ensure the chamfered side is facing up).
2. Depending on your screwdriver, if the arms seem to obstruct the screw holes, you can pre-screw the screws into the wall without attaching the arms first. This will make the final assembly easier.
3. Secure the holder to the wall using screws.
4. Done!

Disclaimer: For those in the US (or other regions where lawsuits are common), use this model at your own risk. Cheers, mates! 😊

• Smaller and slimmer design.
• Slightly larger screw holes.
• Store up to four(4) masks.
• No need for zip bags—simply tie a knot or use a bag clamp.