ITX PC case V2

This is the second version of my ITX case. it's a modular case based on four 15mm x 15mm x 300mm makerbeamXL.

It consists of a lot of parts, but it's easy to sustomize and adapt to your own desires. 

I used an ITX motherboard, Thermalright Peerless Assasin 120, RTX 4070 TI Super, SFF PSU, and some RAM. 
The cooler I used fits perfectly, anything smaller is fine. 
Keep in mind, the RAM hight does matter a bit as they should't be higher than 59 mm (99% of ram will fit)

I wanted a side vent to this PC to leave a clean open estetic to the buid. I loved the idea of a big F1 Fduct 

For a front intake, just take the front from my V1 case. All parts are interchangable between the two. ( https://www.printables.com/model/1066167-itx-case )