Lemmy Motorhead Plaque

Lemmy from Motorhead.

Print in 0.2 mm layers at an infill density of your choice. Make colour changes after every 2 mm of completed print (i.e. at 2.2 mm and 4.2 mm). I used grey, white, then black.

No supports or brim required although you may wish to add a brim for peace of mind. Reduce the print size according to your needs.

Add negative volumes in Slicer to slot in magnets or simply use double-sided sticky tape to attach to a flat surface. 

He was Lemmy, and he played rock ‘n’ roll!

The original design did not have any backing material, meaning that some parts of the model were very thin and fragile or not attached to the main body at all.

This remix stabilises the print and provides a backing to support the original design.