Magnetic Mount for the BTT Smart Filament Sensor v2

I have my Voron installed under the desk, making access to my filament sensor difficult. Therefore, I decided to relocate it to a more convenient place. However, I was unable to use any existing mounts as most of them are dedicated to the Voron frame.

In my bracket mount, you can screw one part to the desk or any other surface and then insert four 6x3 neodymium magnets. Thanks to these magnets, you can quickly and easily detach your sensor when needed.

You may also print an additional support bracket, which can be installed under the table to provide an extra bracket for better stability, though it is optional - in this case use FullSize Version . 
 

Printing:

Filament: Any 

Layer height : 0.20

Perimeters: 4

Top layers: 4

Bottom layers: 3

Infill: 20%

Supports: not needed