Great file it printed well without adjustment.
Flashforge AD5M Door Handle - remixed to print without need of supports
Only change is to angle the overhang so it can print without need of supports
59
620
4
3099
updated
December 31, 2024
Makes
Comments
Another fine remix by Doug that is perfect for the Flashforge AD5X.
Do not print the official handle, because it requires supports badly. Instead print this version. It prints cleanly as it should.
By the way, you can combine this with the "hinge and handle backers" by Wikallen on Printables. That is what Flashforge should publish for their enclosure. (edited)
Fits well with the other enclosure bits, and the magnets were a nice snug fit before glue was added for good measure. (edited)
Regarding the closing being soft, as far as I can remember, I did not edit (remix) the magnet sockets, only the angle leading to the wide handle. I know that some magnets sold on Amazon, and other places, are thinner than the ones shipped in the kit from Flashforge, and it may be that some magnets, if inserted all the way in as deeply as they can go, may actually not be flush or protruding, but rather recessed. That could make for less magnetic hold, and a soft closing effect. (edited)
@design8studio That's exactly what I noticed, I changed some magnets in the project and their quality is inferior, nothing to worry about, thanks again!