kiwi bird - moneybox
Description
PDFReduced details compared to the original so that the print is more FDM-compatible. A cavity and slot for a money box were also added.
Printing is done in four/five parts:
- Body left/right
- Leg left/right
- Pin (2x)
The respective body is glued to the corresponding leg. The left and right halves are connected using two pins.
The fit of the pins must be adjusted depending on the accuracy of the printer. In my case, the two halves fit tightly enough with a little sanding and can still be separated to remove the money.
Additional version of the legs with holes for M3 threaded inserts available. Kiwi was mounted on a wooden panel. Hole spacing is 49 mm.
Tags
Model origin
The author remixed this model.
Differences of the remix compared to the original
Reduced details compared to the original so that the print is more FDM-compatible. A cavity and slot for a money box were also added.
Printing is done in four/five parts:
- Body left/right
- Leg left/right
- Pin (2x)
The respective body is glued to the corresponding leg. The left and right halves are connected using two pins.
