Kobo Clara 2E TPU Case

The design does not support the Kobo Clara BW model, only the 2E. I found the BW cases designs have the power button and USB port locations off by a few millimeters, but the dimensions of the reader overall are very similar.  

This case must be printed with a TPU or other flexible material, or the corners of the case will not stretch over the reader to secure it. I designed this with additional hollow corner bevels, as other case designs could easily slip off. The smaller outside radius on the corners also provide additional cushion in case the unit is dropped.

This was printed using a 0.6 mm nozzle with Duramic 95A TPU. You do not need to print with any supports if your slicer software can perform bridging operations. 

If you like weird fiction novels, I am currently reading There is No Antimemetics Division by qntm.