Magnet on a Stick

I needed to slap a magnet on the end of a rod for a project, so I made this.

Used 1.26" x 1/8" magnet found on Amazon, attached via super-glue (search "1.26" x 1/8" magnet" and you'll find plenty of good examples).

Includes a hole at the top for feeding a loop of rope through and/or drainage.

Printed with PLA in OrcaSlicer with PLA defaults except:

3 Outer Walls
Grid infill at 50% density
No support necessary

→ Note: PETG may be recommended depending on your use case or strength of magnet as PLA can be brittle.

All documents included so you can modify as needed.