Gothic curtain rail end

I styled this after a popular gothic curtain end decoration that's normally made from bent metal. My goal was to make this indistinguishable from the real thing at a distance.

They will fit over a 25mm pole with a snug friction fit. You should be able to scale up or down to depending on your situation, but remember to scale all pieces, including the spirals.

The spirals are not interchangeable due to the slight bevel on the top surface. It's barely noticeable at a distance though.

My prints came out with a very satisfying fit, but results may vary. The inside diameter of the sleeve once printed is 25.7mm

Print Settings

Top layers: 2

Bottom layers: 2

Walls: 2

Infill: 5% Gyroid 

Purposefully printed as light as possible since it's decorative.