Rotující vánoční stromek
Tento model je stejně jako všechny mé modely moje vlastní tvorba, s tím rozdílem, že tady jsem se inspiroval videem z Youtube viz https://www.youtube.com/watch?v=YH9n2VgdkVM
Model je tisknutelný bez podpor a raftů jen u stromku a kmenu jsem použil 10 mm brim.
Výška vrstvy 0,2 mm SPEED a výplň 15 %, ale u kmene doporučuji, alespoň 20-25 %.
Na hvězdu jsem použil pro horní vrstvu vzor výplně Octagram Spiral.
Maximální zvětšení je možné na 135 %, potom už mi Prusa Slicer hlásil chyby a nutil podpěry při tomto nastavení. Při vrstvě 0,15 mm SPEED dokázal slicer bez chyby a vynucení podpěr naslicovat i zvětšení na 150 %.
Ať se Vám model líbí a budu rád za ukázky vašich výtisků.
--------------------------------------------------------------------------------
Rotating Christmas tree
This model is my own creation, just like all my models, with the difference that here I was inspired by a video from Youtube, see https://www.youtube.com/watch?v=YH9n2VgdkVM
The model is printable without supports and rafts, only for the tree and trunk I used 10 mm brim.
Layer height 0.2 mm SPEED and infill 15%, but for the trunk I recommend at least 20-25%.
For the star, I used the Octagram Spiral infill pattern for the top layer.
The maximum magnification is possible at 135%, then Prusa Slicer reported errors and forced supports at this setting. With a layer of 0.15 mm SPEED, the slicer was able to slice even at a magnification of 150% without errors and forcing supports.
I hope you like the model and I will be happy for samples of your prints.
The author marked this model as their own original creation.