Soap Vise - In Development

**In development

This is a little device I created for those little bits of extra soap. Now you can compress them into a new bar. Screw in the bottom, place all those little bits of soap, add some hot water and compress. Once you are satisfied unscrew the bottom and push out your new bar. This is the first revision so let me know if you any suggestions.

After first print (printed in PLA Matte), tolerances are too tight. Lid and bottom need adjusting so they don't get stuck. First time using screws, top screws thread but are too tight and break after a few turns, can't get bottom to start.

Will work on revisions.