Fidget Slider with interchangeable textures and magnets

This modular fidget slider uses two magnets and an interchangeable texture plate to create maximum satisfaction. 10 different texture plates are included in the model files.

There are 4 printed pieces:

The base, the housing, the texture plate and the slider.

In addition you'll need 2 magnets: one 4mm cube and one 4-6mm cylinder or sphere (I used a d5h4 cylinder)

Printing:

Print all pieces with the largest side down, no support material required.

0,15mm layer height recommended. The texture plates benefit from adaptive layer height to make them smoother.