Roll Dispenser Stand (parametric)

This model should work for a large range of rolls but, as is, it is made to fit a Ø32mm gift wrapping roll. You can modify the parameters of this model in In Fusion360 to suit your needs.

Printing information:

• Split the model to its parts and print them all on their flat face
• The roller is filled-in for ease of printing, you can use 5% infill without issues to print it.
• You will need to print the whole model twice, one for each end of the roll

Assembly:

1. Slide the roller inside your roll
2. Slide the stand onto the pin of the roller
3. Lock the stand in place by sliding the cap thought the stand into the roller pin.
4. Screw the stand into a plank (or similar) to secure it in place (Ø4mmx8)