Storage Rack for Powertec Pec- Fly Attachment

The Powertec-Fly attachment can be tricky to store. I made this storage rack from a leftover superstrut (Unistrut). It's still a work in progress, but it's fully functional. I used a 19 mm box offset wrench to tighten the bolt inside the receiver. Estimated cost: ~$60.

If there is sufficient demand, I can design a receiver for a two-by-four stud, which would be significantly more economical.

Printed on a Sovol + with a 0.8 nozzle, this took 2 hours print with an adjustable height and 80% infill. PLA+. 

Parts list: