Voron v0.1 lid holder

Needed a way to mount the lid and door of my Voron v0.1 out of the way while printing PLA and PETG. 

So this is the solution.

You will need to print a minimum of two copies as it might be a challenging balancing act 

other vice.

Mine is just mounted to the side of a Ikea bookshelf with VHB tape, but there is holes to use screws if you rather do that.

Print on it's side, 0.2mm layers and 15% infill works fine.

My copy is printed in Anycubic - PLA Pantone - Spring Leaf.