2014-2021 vent adaptor for Ainope phone mount

I hated all the vent holders out there and our Sequoia didn't really have a better place to place a phone.  Everything on the market bends the vents blades and are a flimsy connection. I think the models are 2014-2021.  I know it fits a 2021.  There may be others it fits as well but I don't know.  This divides all the pressure against 5 blades and the bottom rests on the bottom of the vent to take the weight off the blades.  I printed the body in PC-CF to be better for the heat of the vent and summer temps.  The pads I printed in TPU to prevent any rubbing. I used epoxy to stick them to the body.  The large one goes on the angled part of the inner body.  You need 10 of the smaller ones that go on the outer body to pad the front of the vent blades.  The smaller ones are printed longer than needed so they are easier to glue on.  I align them to the outside and overhang on the inside then cut off the extra from the inside with a blade after the glue dries.   The center gasket is printed in TPU as well and it goes between the outer body and the phone holder to make up for the length of the hook has to grip the vent blade.  I used four 4mmx12 socket head cap screws and 4 inserts