Galaxy's Edge Legacy Saber Box Kyber Crystal Display - Remix

Remixed inserts for Disney Galaxy's Edge Legacy Lightsaber boxes to hold Series 2 Kyber Crystals. It has been remixed to hold 6 crystals each side vertically since because of their larger size they fit better. You will need to remove the 2 pieces of foam in the lid in order to close the case. The foam is held by tape but may be very hard to get ut loose, be careful with the lid doing this. I replaced it with a thin layer of foam, but it isn't necessary, it just keeps that from rattling when the box is closed.

Thanks to ravonus for his original design for Series 1 crystals, https://www.thingiverse.com/thing:4896640.

Printing: Very easy print to print. Print this in the same position as it will be used, with the bottom side on the printer bed. No supports should be needed as the overhang angles should print with no supports. I used 15% infill with a 0.2 layer height. You may be able to get by with 10% supports but I haven't tried that.

Remixed inserts for Disney Galaxy's Edge Legacy Lightsaber boxes to hold Series 2 Kyber Crystals instead of Series 1 Kyber Crystals that are in the original design.