Christmas Ornament - Teardrop Sphere

Print this with the flat base down. No support is required. Use a brim for stability. I used 15% Support Cubic infill starting at ~1 inch (26 mm) to support the top of the sphere. Do not use vase mode. The default size is 3.15 in (80 mm) diameter, but it can be freely scaled. I found 70 mm works better with some of the ornament holders available on Amazon.

I recommend silk PLA, single or multi-color.

Note: the block that appears at the bottom of the 3mf file is just the modifier to prevent infill at the bottom so that you can insert the ornament holder.