Universal Case

Just a simple case for screws, nuts or other fine mechanical components.
The choice is yours ;)

 

Tips for printing:

• Use a relatively low infill (I recommend 5-10%) since the top of the case is essentially a solid block of plastic. A higher infill might cause twisting or warping.
   
• The hinge is designed to be filled with a piece of filament straight from the spool. If needed, you can also widen the hole slightly with a 1.8mm drill bit for a better fit.
   
• The closure is designed to be held in place by (strong neodymium) 3x1mm magnets, but will work just fine even without them.
   

Tell me in the comments if you have any tips or recomendations. :) 

Thanks for checking my model ;)