1:16 Diecast Car Wall Mount (With ramp)

I have created a custom ramp mount for 1:16 scale diecast cars.

The ramp allows the car to sit at an angle, and has enough stops in the front so it cant roll off of it.

There are also raised edges on the side back for added protection from rolling.

For now I have made a single car mount, so you would need to build multiples and assemble\mount individually, but may work on a dual (or even triple, quad etc.) in the future if interest is drummed up for it.

The parts needed to print:

• 2 long dowels
• 2 short dowls
• 1 pedestal
• 1 base
• 1 ramp

NOTE: I highly recommend gluing the dowels to the pedestal\base during assembly as I do not know how well it can hold up over time with just friction. 

For assembly please refer to the PDF in the files list below. 

Have fun and show me your makes :-D