Gardena ClickUp Bird Bath

This bird bath uses the Gardena ClickUp System to be mounted on the Gardena Stick.  

I have tested the waterproofness with multiple prints. The results are that you need to use high-quality filament and also make sure it is dry. Otherwise, the water will slowly seep through. (Prusament, Verbatim work).

But not to worry, a simple coat of paint can fix that.

Printing with 0.2 mm speed preset, it works on MK3/S/+ and MK4/S

The bird bath printed with 15% infill and 3 perimeters is strong enough to support at least to doves sitting on the side at once (That is the most I have observed. Probably it will hold even more)

The Gardena connection should work, but if too tight or too lose, you can slightly adjust the scale of the model than it should fit. (You can test print the other models I have with this system)