Made it on my Comgrow T300 because a PETG blob ate my Qidi Plus 4 hotend.
This turned out amazingly well. The design is over the top. After installing, I had to turn down the cooling b/c it works so well.
Great Model! Well Done!
Qidi Plus 4 Single Piece Part Cooling Fan Housing
Qidi Plus 4 Single Piece Part Cooling Fan Housing. instead of two parts, made a printable single piece part cooling fan
36
152
2
751
updated December 31, 2024
Makes
Comments
Printed very easily in Polymaker ASA. Used a brim and the orientation shown. Didn’t require much support.
@Rhiz0matics_2506753 print orientation as vertical standing on one side as in the last picture?
@camelCaseOnly_275138 whatever works or you, use supports, I use tree hybrid.