R/C battery charger stand

This is a simple stand I made for my battery charger. My charger is used in a specific spot so the stand holds the charger at an angle for easier viewing. Someone else may find it handy for themselves. The top of the stand is 150x150mm with approx 65mm rise at the rear. The stand can be printed without support material when printed on its side as shown.

Print Settings

Printer Brand:

Prusa

Printer:

i3 MK3

**Rafts:**

No

Supports:

No

**Resolution:**

0.20

Infill:

10

**Filament:** Esun PLA White

Notes:

The stand can be printed without support material when printed on its side as shown.

Category: R/C Vehicles