this a special made shroud that will work for the Rogue 6 airsoft GBBR. it uses it own outer barrel system.
like other UNW 248 shrouds this made for a 248mm outer barrel but if you want longer barrels could be used
use the R6 model for airsoft / gelsoft
when the M2 front is used then you might want to use the full length outer barrel
-
9 users note: this for the metric version only at the moment
---
installation:
it is show in the images.
the M4 metal threaded rods will need the size of.
1x 402mm long (measured from the inside of the 2 nuts on the back!)
ad + 7mm to the top rod when used with the collapsible stock P9/6 end cap
2x 226mm long (measured from the inside of the 2 nuts on the back!)
---
material needed:
1x torx flat head screw countersunk m3 10mm long bolt
1x torx flat head screw countersunk m3 25mm long bolt
for Outer barrel
1x M3 bolt that is 18mm up to 25mm
---------
print settings
fallow the PDF for print settings
my print orientations at not correct see the how to print manual for this and notes on supports
The author marked this model as their own original creation.