EOD Digging Knife and Nonconductive Probe

Here is a simple digging knife that is pointy enough to break up dirt, but sturdy enough to not snap immediately. Great for uncovering and finding buried items of all shapes and sizes. Most of all, it looks cool. 

Printing Instructions:

Material: PLA, PETG, ASA

Speed: 60-150mm/s depending on your printer's part cooling capability. If you have poor part cooling, print this model at 60 mm/s.

Part Cooling: 100% fan recommended to print the steep overhang at the knife tip

Supports: None needed if you have a printer with good cooling/bridging. Use paint on supports below the knife tip if you have issues printing this. 

Bed Adhesion: Gluestick on bed recommended to prevent warping

Infill: 30% minimum

Walls: 4 minimum