Soccer ball keychain
In STL model is little bit angular but when you 3D print it you don't see it. The hole measure 5 mm.
1
20
0
100
aktualisiert
19. Februar 2025
Beschreibung
PDFI recommend 20% infill. No supports. Printing takes approximately 3 hours. Blacks spots are a little bit higher so you can change filament and it can be two-colored.
If you like it please live a like, it is free and you can always change your mind and it helps a lot.
Tags
Herkunft des Modells
Der Autor hat dieses Modell als seine eigene Kreation gekennzeichnet.